DiversiTech In-Line Fuse Holder 1-1/4 EM480

The DiversiTech EM480 is an in-line fuse holder sized for 1-1/4 inch fuses, providing a compact means of adding fuse protection within a wiring run rather than at a panel or terminal block.

In-line holders are used where a dedicated fused disconnect or panel position is unnecessary or impractical. The holder splices into the conductor being protected, placing the fuse directly in the circuit at the point where protection is needed. This is common in equipment control circuits, accessory circuits added during retrofit work, and applications where a small load branches from a larger feeder and requires its own protection sized to its conductors.

For HVAC and refrigeration work, typical uses include protecting low voltage control circuits, accessory loads such as condensate pumps and inline duct fans, aftermarket controls and monitoring devices added to existing equipment, and any circuit where the branch protection upstream is too large to protect the smaller downstream wiring.

The holder accepts standard 1-1/4 inch fuses, a common size covering a wide range of amperage ratings, so the same holder supports different protection levels by fuse selection. That makes it convenient to stock a single holder type alongside an assortment of fuse values.

Installation involves cutting the conductor, terminating both ends into the holder body, and securing the assembly so it is not left hanging under tension. The holder should be positioned where it remains accessible for fuse replacement without dismantling the equipment.

Verify the voltage and current rating of the holder against the circuit, select the fuse to protect the smallest conductor in the branch, and comply with applicable electrical code.

Brand

DiversiTech

SKU

EM480

Category

Fuse Holders

Weight

0.12 lbs

Dimensions

6.00" x 1.00" x 1.00"

Price

$19.00

Availability

In stock

Rating

0 / 5.0